CREEPING BENTGRASS SEED
A great blend of Pencross, Peneagle, and Penlinks creeping bent grasses. A fine-leaved, cool-season perennial which is adapted to cool and humid regions. Tolerates low temperatures and relatively poor, wet soils. Used primarily on golf courses for putting greens and winter overseed; produces high quality turf. The grass of choice for lawn bowling. Likes full sun, but will tolerate some shade. Requires frequent mowing, or will build an extensive thatch layer.
Seeding rate 1 lb/750 sq.ft.
"Penncross" Creeping Bentgrass
Aggressiveness, vigor, and wear tolerance make Penncross a natural for greens, tees, and fairways. Penncross' ability to perform under a wide range of conditions makes this bentgrass adaptable virtually worldwide. Golf course architects have specified Penncross for areas of extreme cold and heat, and Penncross has survived humidity where bermudagrass used to be the standard.
Penncross is designed for extensively managed golf greens and tees and lawn bowling surfaces. Penncross performs best in soils with a pH of 5.5 to 8. It has a moderate nitrogen requirement with 1-2 pounds of actual N per 1,000 square feet per year adequate in most situations. Penncross' optimum mowing height is 3/16 to 5/16 inch but can be adjusted higher or lower depending upon maintenance practices and intended use. Penncross performs best on a sandy soil and tolerates clay soils with adequate drainage. Most bentgrasses do not perform well in wet areas, however, Penncross can tolerate saturated soil conditions for short periods of time.
Penncross can be seeded from 1-2 pounds per 1,000 square feet depending on the application. Cover seed to a depth not exceeding ¼" and keep seedlings moist until well rooted. Germination will take place in 7-15 days depending on soil temperatures, and the first mowing may be expected within 30 days, or when the plants have sufficiently rooted. Mow at a 3/4" height of cut or lower until turf is established. Limited use of the area can be expected in 6 weeks.
Seeding rate 1 -2 lbs/1000 sq. ft.
"Penneagle" Creeping Bentgrass
The top performing fairway bentgrass. Penneagle germinates quickly and has an upright, dense growth habit which helps crowd out Poa annua. Penneagle is salt tolerant. While not as aggressive as Penncross, the new variety competes with Poa annua on fairways, and with tripler mowers and clipping removal, will crowd out the nuisance entirely. Penneagle's salt tolerance makes it useful along coastal areas and where effluent water is used.
Studies have shown that Penneagle has a wide adaptability, tight, more upright growth characteristics than Penncross, and has a finer leaf than most other creeping bents.
Seeding rate 1-2 lbs/1000 sq ft.
"Pennlinks" Creeping Bentgrass
Developed for grainless greens, PennLinks became an instant success when introduced in 1987. PennLinks has upright, dense growth for true putting, dense growth for true putting. PennLinks has fine texture and heat tolerance. --- When Dr. Joe Duich developed PennLinks exclusively for putting greens, he was looking for an upright growing, virtually grainless putting surface that would perform predictably over a broad climatalogical range. With vacationing golfers comparing surfaces all over the world and a playing professional's reputation 'on the line' with each putt, a universally manageable, premium quality surface was the order.
Seeding rate 1 lb/750 sq.ft.
"Seaside" Creeping Bentgrass
Same basic qualities as other bentgrasses, but is the old version. Penntrio's blends are the new improved varieties, but Seaside still is a quality seed for less money. Salt tolerant Seaside was developed exclusively for fairways and is useful along coastlines and where effluent water is used for irrigation. Seaside has shown the ability to thrive under high pH conditions.
Seeding rate 1 lb/750 sq.ft.
Bentgrass (Agrostis) is a large genus with over 100 species, but
only about four are used for turfgrass in the United States. None of these
four are well adapted to southern climates. The only use of this species
in the South is for golf course putting greens where environments are closely
Throughout the New England States and the Pacific Northwest where climatic conditions are ideal for bentgrass, the species is used for lawns, athletic fields and golf courses. In Europe and parts of Asia, the grass is native and commonly found on lawns, pastures and sport fields.
Of the four species used for turf, creeping bentgrass is the one most commonly used on southern golf greens. The species was introduced into the United States from Europe during the Colonial Period.
Description. Creeping bentgrass (Agrostis palustris) is a
perennial cool season grass that forms a dense mat. The grass spreads by
profuse creeping stolons and possesses rather vigorous, shallow roots. Stems
(stolons) are decumbent (creeping) and slender and produce long narrow leaves.
Leaf blades are smooth on the upper surface and ridged on the underside,
1 to 3 mm wide and bluish green in appearance. The ligule is long, membranous,
finely toothed or entire and rounded, auricles are absent.
The species is characterized by single flowered spikelets in a compact panicle. The panicle in flower is purple to bronze in appearance. Seed of creeping bentgrass are too small to be identified without magnification. Seeds are ovate, less than 1 mm long, usually awnless with an occasional short, straight awn and silvery in appearance.
Adaptation and Use. Creeping bentgrass is adapted to cool, humid environments such as those found in the northeastern United States. Cool nighttime temperatures are particularly advantageous to bentgrass. In the South, high daytime temperatures together with warm nighttime temperatures create highly adverse conditions for bentgrass. During summer months in the South, carbohydrate reserves are depleted in bentgrass and the turf becomes susceptible to any additional stress - drought, traffic, shade, insects or disease.
As a result, the only use of bentgrass in the South is for golf greens where small acreage allows for very intense management. In the South, bentgrass is best adapted to the transition zone where cooler temperatures prevail. But even in this area, special attention needs to be given to soil preparation, water management, air circulation, shade, exposure and other factors.
Varieties. Presently, only the seeded varieties of bentgrass are used in the South - Seaside, Penncross, Emerald, Penn Links, Cato, Crenshaw, SR1020 and Penneagle. A number of vegetatively propagated strains of bentgrass are used in the northern states, but they have found very limited use in the South. These include Cohansey (C-7), Toronto (C-15), Congressional (C-19), Nimisilla, and some local strains propagated on individual sites.
Seaside creeping bentgrass is the oldest seeded variety in use today. It is an extremely variable grass that develops into patches of individual strains with different colors, textures and densities. The seed supply for Seaside is harvested from natural stands indigenous to the coastal regions of Washington and Oregon.
Penncross is a more uniform variety with superior turf quality, disease tolerance and wear tolerance. Where play is heavy, Penncross is probably the better choice. Penncross was released by Pennsylvania State University in 1954. Seeds are harvested from crosses of three vegetatively propagated strains.
Emerald, Penn Links, SR1020, Cato, Crenshaw and Penneagle are newer varieties of bentgrass that have seen only limited use in the South.
Propagation. In the case of bentgrass, particular attention needs to be given to seedbed preparation. Well drained soil mixtures are essential for growing bentgrass in the South. Highly permeable mixtures of sand and organic amendments placed over a drainage system are commonly used for bentgrass green construction.
Seeding rates for bentgrass golf greens vary from 0.5 to 1 pound per 1,000 sq. ft. If mulch is applied over the seed, about 50 pounds mulch per 1,000 sq. ft. are used. Light, frequent watering is necessary on these highly permeable green's mixtures to keep the seedbed moist. The mulch may reduce the frequency of watering from 5 to 7 times per day to 2 to 3 times per day. Under ideal conditions germination may begin five days after seeding.
Frequent fertilization is also helpful to establish a cover of bentgrass on these sand mixtures. A starter fertilizer might be applied before seeding and one month later. Soluble nitrogen fertilizers can be applied at light rates at 10-day intervals after seeding until a complete cover develops.
Early fall is the best time to seed bentgrass in the South. Spring planting dates do not allow adequate growing time for plants to mature prior to summer stress.
Management. Intensive management and frequent observation are keys to the success of bentgrass golf greens in the South. Watering, fertilization, mowing, cultivation, and pests must be closely managed to keep bentgrass greens during summer months.
Water must be closely managed to meet the moisture needs of the grass, but not exclude oxygen from the soil. Water also serves to moderate the temperature during heat stress periods. Watering schedules and rates must be based on water use rates (evapotranspiration) and the water holding capacity of the soil. During summer months, watering practices may determine success of failure with bentgrass. Well drained greens (permeable soil mixtures and good surface runoff) and well designed irrigation systems give the turf manager an edge on bentgrass greens. At times little or no irrigation may be needed; at other times, very light applications of water (misting) may be needed to cool the turf by evaporation from the leaf surface.
The turf manager must closely manage the water needs of bentgrass during heat stress periods. Excess water, or saturated soils, can be as damaging as insufficient water during heat stress. The successful turf manager matches irrigation rates to water use rates (evapotranspiration) and uses a misting system to cool the turf during mid-day stress.
Fertilization practices are also critical on bentgrass greens. The successful manager plans fertilizer applications to promote growth without depleting carbohydrate reserves. During cool periods such as fall and early spring, fertilizer promotes stolon and leaf growth as well as carbohydrate storage in stolons. However, late spring and summer applications of fertilizer promote leaf and stolon growth at the expense of carbohydrate reserves. Thus, very little fertilizer should be used between June and September on bentgrass greens. Perhaps monthly applications of nitrogen at 0.5 pound per 1,000 sq. ft. can be made from October to May and 0.25 pound per 1,000 sq. ft. from June to September for a total of about 5 pounds of nitrogen per 1,000 sq. ft. per year.
In addition to nitrogen, potassium, phosphorous, and iron are required on most golf greens. Soil and plant tissue analyses will alert the turf manager to specific needs of bentgrass for these nutrients. On an annual basis, 1 to 2 pounds of phosphorous, 4 to 5 pounds of potassium and several foliar applications of iron are generally needed. But, soil and tissue samples will indicate specific nutrient needs.
Mowing heights of 3/16-inch or less are common on bentgrass greens. But, during summer stress periods raising the height to 1/4 inch helps the bentgrass survive heat stress and tolerate wear.
The use of walking greens mowers in place of riding mowers also helps keep bentgrass greens through the summer. If riding mowers are used, turns should be made off of the putting surface.
Cultivation practices, including aeration, vertical mowing and topdressing, need to be done during the fall and spring on bentgrass greens to avoid added stress during the summer. All of these cultivation practices help the turf manager control thatch, graininess and compaction on bentgrass greens.
To effectively control insect and disease problems, frequent surveillance is essential. Sod webworms, cut worms, mole crickets and white grubs need to be treated as soon as the insects are found. In the case of sod webworms, as many as 4 or 5 generations may occur in a single year.
Effective disease control requires preventive applications of fungicides for dollar spot, brownpatch and other disease problems. Turf managers must be alert for development of diseases during warm, moist conditions.
Richard L. Duble, Turfgrass Specialist
Texas Agricultural Extension Service
Text copyright © Richard Duble.